|
shenzhen OCT-TECH CO. LIMITED
|
BMW EWS EMULATOR
| Place of Origin: | , China (Mainland) |
|
|
| Add to My Favorites | |
| HiSupplier Escrow |
Product Detail
INSTALLATION:
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator
must be
INSTALLATION:
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator
must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
CONFIGURATION UTILITY:
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator
must be in service mode: JUMPER 1 shorted.
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR
CONFIGURATION UTILITY:
3. Choose COM port, write in desired ISN number, press button Store. Or-
4. For some ECU's it is possible to read ISN number directly from engine control unit. In this case
select option "ECU xxxxx", press Read. Software will try to read ISN. If successful, choose option
"EWS emulator" and press button Store to save ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to
DME(DDE)<>EWS line.
6. Don't forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.
In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to
diagnostic K-fine.
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.
4. For some ECU's it is possible to read ISN number directly from engine control unit. In this case
select option "ECU xxxxx", press Read. Software will try to read ISN. If successful, choose option
"EWS emulator" and press button Store to save ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to
DME(DDE)<>EWS line.
6. Don't forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.
In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to
diagnostic K-fine.
There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.
Didn't find what you're looking for?
Post Buying Lead or contact
HiSupplier Customer Service Center
for help!
Related Search
Find more related products in following catalogs on Hisupplier.com
Related Products
Company Info
shenzhen OCT-TECH CO. LIMITED [China (Mainland)]
Business Type:Manufacturer
Country/Region: China (Mainland)
